EN
7
dehumidifier TTK 655 S
Stacking
After
transporting the device, observe the following:
•
Set up the device in an upright position after transport.
•
After having transported the device in horizontal position,
leave the device to rest for 12 to 24 hours, so the
refrigerant can accumulate within the compressor. Wait
12 to 24 hours before switching the device back on! Acting
contrary might lead to compressor damage and a
malfunctioning device. Any warranty claims will be voided
in this case.
Storage
Before
storing the device, observe the following:
•
Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Drain any possibly remaining condensate.
When the device is not being used, observe the following
storage conditions:
•
Only store the device in a room measuring more than 4 m
2
.
•
Only position the device in rooms where there is no source
of ignition (e.g. open flames, an active gas appliance or an
electric heater).
•
dry and protected from frost and heat
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust, if necessary
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
Assembly and installation
Scope of delivery
•
1 x Device
•
1 x Air filter
•
1 x Condensation drain hose, 15 mm diameter
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
