4
EN
dehumidifier TTK 165 ECO / TTK 170 ECO / TTK 380 ECO
Residual risks
Warning of electrical voltage
Work on the electrical components must only be
carried out by an authorised specialist company!
Warning of electrical voltage
Before any work on the device, remove the mains plug
from the mains socket!
Hold onto the mains plug while pulling the power cable
out of the mains socket.
Warning
Dangers can occur at the device when it is used by
untrained people in an unprofessional or improper way!
Observe the personnel qualifications!
Warning
The device is not a toy and does not belong in the
hands of children.
Warning
Risk of suffocation!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.
Note
Do not operate the device without an inserted air filter!
Without the air filter, the inside of the device will be
heavily contaminated. This could reduce the
performance and result in damage to the device.
Behaviour in the event of an emergency
1. Switch off the device.
2. In an emergency, disconnect the device from the mains
feed-in: Hold onto the mains plug while pulling the power
cable out of the mains socket.
3. Do not reconnect a defective device to the mains.
Information about the device
Description of the device
The device uses the principle of condensation to automatically
dehumidify rooms.
The fan sucks damp room air through the air inlet, the air filter,
the evaporator and to the condenser located behind it. The air is
cooled at the cold evaporator until it is below the dew point.
Water vapour contained in the room air precipitates on the
evaporator fins as condensation or rime. The dehumidified,
cooled air is slightly warmed at the condenser and blown out
again. The drier air thus conditioned mixes with the air in the
room. The humidity in the room where the device is positioned
is reduced as air constantly circulates through the device.
Depending on the air temperature and the relative humidity, the
condensed water either drops continuously or only during the
defrost phase through the integrated drain nozzle into the
condensation tank below. It is fitted with a float to measure the
filling level.
In case of the device
TTK 165 ECO
defrosting takes place
electronically in air circulation mode.
The devices TTK 170 ECO and TTK 380 ECO come with a hot
gas automatic defrost system. Here, the hot gas of the
refrigerant circuit is used actively for fast and effective
defrosting. This makes the devices TTK 170 ECO and
TTK 380 ECO considerably more effective at temperatures
below 15 °C.
Once the maximum filling level of the condensation tank is
reached or in case the condensation tank is not installed
correctly, the condensation tank indicator light (see chapter
Device depiction) is illuminated. The compressor and fan will
switch off. The condensation tank indicator light only goes out
again once the emptied condensation tank is reinserted.
If required, an external hygrostat can be connected to the
devices TTK 170 ECO and TTK 380 ECO for controlling the
humidity level. Moreover, an operating hours counter helps you
to meet the maintenance deadlines.
Optionally, the condensed water can be drained by attaching a
hose at the condensation connection.
The device can reduce the relative humidity of a room to approx.
30 %.
Because of the heat radiation generated during operation, the
room temperature may rise slightly.
Info
The illustrations in this operating manual feature the
device
TTK 170 ECO
by way of example. However, the
depicted operating steps and explanations also apply to
the devices TTK 165 ECO and TTK 380 ECO unless
otherwise mentioned.
