EN
4
Operating manual – dehumidifier TTK 110 HEPA
Device depiction
1
2
3
4
5
7
8
9
10
6
No.
Designation
1
Control panel
2
Air inlet (behind cover)
3
Condensation drain hose connection
4
Air filter
5
HEPA filter
6
Condensation drain hose
7
Condensation tank with filling level indicator
8
Air outlet
9
Transport handle
10
Wheels
Transport and storage
Transport
Before
transporting the device, proceed as follows:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
•
To make the device easier to transport, it is fitted with
wheels.
•
Do not use the power cable to drag the device.
•
Only wheel the device on a level and smooth surface.
After
transporting the device, observe the following:
•
Set up the device in an upright position after transport.
•
Leave the device to rest for 12 - 24 hours, so the
refrigerant can accumulate within the compressor. Wait
12 - 24 hours before switching the device back on! Acting
contrary might lead to compressor damage and a
malfunctioning device. If so, any warranty claims will be
voided.
Storage
Before
storing the device, proceed as follows:
•
Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
•
Empty and clean the condensation tank prior to storage.
•
Carry out the self-cleaning function to prevent the
formation of moisture within the device during a longer
period of non-use.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust if necessary
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
