7
EN
Operating manual – gas heater fan TGH 10 E / TGH 15 E / TGH 30 E
2. Use the screws and washers to mount the transport
handle.
Connecting the gas cylinder
Info
Use tools suitable for the intended task.
Make sure not to damage the valve seal.
Damage could lead to a point of leakage at the gas
connection. And leaks connote an explosion hazard!
Info
The pressure reducer included in the scope of delivery
is only suitable for gas cylinders from the following
countries of destination: Germany, Austria, Belgium,
the Netherlands and Poland.
For all other countries of destination, a suitable
pressure reducer must be purchased separately.
Info
Once assembled, do not turn the pressure reducer!
Rotating the pressure reducer after completed
assembly could cause damage to the valve seal at the
gas cylinder.
Damage could lead to a point of leakage at the gas
connection. And leaks connote an explosion hazard!
If you transported the gas cylinder, let it rest for about 1 hour in
an upright position before connecting it. That way, the particles
that are harmful to the environment have time to settle at the
bottom.
1. First connect the pressure reducer to the gas cylinder. To
do so, screw the union nut of the pressure reducer in a
counter-clockwise motion onto the thread of the gas
cylinder.
2. Connect one end of the gas hose to the pressure reducer.
For this purpose, screw the union nut of the gas hose onto
the external thread of the pressure reducer by turning it
counter-clockwise. Use an open-end wrench of size SW 17
or SW 19 to do so.
Please note that the gas hose must not be kinked or
twisted.
3. Remove the protective cap from the hose connection at the
device.
