4
EN
radial fan TFV 29 FS
Information about the device
Device description
The device TFV 29 FS was designed for a very high air flow rate.
It may be used for drying carpets, buildings or screed as well as
for the ventilation of poorly accessible intermediate spaces.
Owing to the high air circulation, the device can also be used to
control excessive humidity levels. The fan is also very effective
for the additional air circulation when heating large buildings,
e.g. in the months of winter.
The device can be set up in four drying positions for different
surface drying applications. The stand bar integrated at the
bottom can be folded out for tilting the device, thus permitting
the ventilation and drying of walls or entire stairwells. If the
device is positioned directly on the ground, the entire
discharged air is distributed at high speed in a broad, near-
ground air current, making this position ideal for accelerated
surface drying. In upright position, the device can be used for
well-directed ventilation and drying of the ceiling. When
positioned on the edge with the air outlet pointing to the side,
the device can be used for ventilation and drying of confined
spaces or extensive wall surfaces.
The device is further equipped with a service socket, which
means that you can operate additional devices via the same
socket. This socket is ready for operation for as long as the
device is connected to the mains – it does not need to be
switched on.
The devices can be stacked on top of one another for space-
saving storage. Do not exceed the maximum of five stacked
devices. Additionally, the device is fitted with integrated cable
holders allowing you to wind up the connection cable.
Device depiction
5
2
1
6
4
3
7
8
No.
Designation
1
Operating hours counter
2
Air outlet
3
Fold-out stand bar
4
Cable holder
5
On/off switch
6
Service socket
7
Air inlet
8
Transport handles
