Pre-Installation Instructions
8014 Trotec Speedy 500
Laser Machine Requirements
13/12/2011
Trotec Produktions- und Vertriebs GmbH
_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support
4 / 15
tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, mailto:
1.3 Unloading of the crate and machine
The Speedy 500 is transported in a wooden crate.
A suitable fork-lift is required to unload from the courier vehicle and lift the machine off its pallet.
A powered screwdriver with cross-head bit is recommended for dismantling the wooden crate.
If possible keep the packaging in case the machine ever needs to be relocated or shipped for any
reason.
Perform the following steps to unpack the machine properly:
1 Dismantle top and rear of the crate.
2
Remove all tables and accessory found in the
slots on the rear.
3 Remove the front and side plates.
4
Remove the transportation safety device.
Front: mid, back: left, right, mid (PSU-vat)
5
Open door on the front door of
Speedy500 (10mm Allen-Key).
6
Follow the safety instructions!
Caution:
Lift only on indicated lifting points!
Lifting the machine on any
other point will cause
extensive damage.
Only lower the machine onto an even surface.
7
Lift Speedy 500 with forklift on
indicated lifting points. Adjust rollers
and feet as necessary.
8
Remove the transportation safety device of the
x-axis.
9 The machine must be allowed to stand for 24 hours before use.
