Trotec Speedy 400, Руководство по эксплуатации

Страница: 75 / 89

Troubleshooting
9 Troubleshooting
This chapter should enable the maintenance personnel to identify and resolve operational faults based on error
messages and symptoms.
Warning
Risk of fire from incorrect parameter settings
.
Laser operation with incorrect parameter settings such as power settings, speed or frequency can result in
flame formation.
–
Laser operation permitted only under supervision.
Caution
System failures that cannot be remedied can cause damage to the machine.
– Disconnect the machine from the mains and contact your local Technical Support.
9.1 Error, cause and remedy
Problem Possible cause Remedy
Too low engraving depth.
•
Imprecise focusing.
•
Dirty optics.
•
Check focus.
•
Clean optics.
Blurred edges.
•
Imprecise focusing.
•
Check focus.
Missing cut lines.
•
Zero passes in material database.
•
Line thickness in CorelDraw too
big.
•
Color was skipped in the
soware.
•
Increase the amount of passes in
the material database.
•
Reduce line thickness to the
smallest possible value.
•
Set color to cutting in the
database.
Waviness of the lines.
•
Lens is loose.
•
Check lens and lens holder.
No visible marking result.
•
Too low laser power.
•
Too high speed.
•
Not focused.
•
Wrong focus tool.
•
Increase power setting.
•
Reduce speed.
•
Check focus.
•
Change focus tool.
•
When using autofocus, check the
settings within the soware (lens,
material thickness, table).
Fine details on stamps are
engraved too thinly.
•
Too steep shoulders.
•
Choose other shoulder or edit
(flat/medium/steep): Options/
Process Options/Stamp.
75