EN
11
planer PPLS 10-750 / PPLS 10-800
Please proceed as follows to attach the chip ejector to the other
side of the device:
1. Detach the chip ejector (
2
) by turning it in the opposite
direction of the arrow (LOCK).
2. Pull the chip ejector out of the device (
2
).
1.
2.
2
3. Clean the chip ejector if necessary.
4. Slide the chip ejector into the device on the other side. Pay
attention to the position of the opening at the device and of
the notch at the chip ejector while doing so.
5. Lock the chip ejector (
2
) by turning it fully in the direction
of the arrow (LOCK). The opening of the device and of the
chip ejector must fit each other precisely so that all dust
and chips produced will be discharged.
2.
1.
2
Connecting the power cable
1. Insert the mains plug into a properly secured mains
socket.
Operation
Tips and notes on handling the planer
General information:
•
At the beginning, only position the front part of the device
on the workpiece.
•
Only guide the part of the device where the cutting head is
located against the workpiece after the device has been
switched on.
•
Guide the device over the workpiece in an even forward
motion. Hold onto the device with both hands; one hand at
the rotary knob (
4
) and the other one at the device
handle (
19
). The front and rear base plate should fully rest
on the workpiece.
Planing:
•
Use sharp blades only. Worn blades can yield an uneven
result.
•
If you want to use the full planing width or process hard
wood, we recommend choosing a small cutting depth and
working with a slow forward motion.
•
For a higher surface quality, we recommend applying the
pressure on the centre of the device and working with a
slow and even forward motion.
Using the lift-off device
The lift-off device serves as an aid when putting the device
down and for protecting the workpiece.
Note
Never remove the lift-off device from the device. A
missing lift-off device causes instability of the device
and can damage the workpiece or device.
Please proceed as follows to use the lift-off device:
1. Make sure that the lift-off device (
14
) folds down when the
device is lifted, and put the device down safely.
14
