Trotec POWERSHRED, Руководство по эксплуатации

Страница: 6 / 28

B - 5
Infrared Camera – Operating Manual EN
03. preparInG the Ir CaMera
Charging the Battery
Proceed as follows when charging the battery for the
first time. This procedure also applies for all subse-
quent charging cycles, which have to be carried out
when the symbol showing that the battery power is
too low lights up in the display.
1. Position the edge of
the charger so that
it is on the same le-
vel as the line on the
battery and insert the
battery in the direc-
tion of the arrow.
2. Attach the power
cord to the battery
charger and plug the
other end into a po-
wer outlet.
• The charge indicator lights up red while the battery
is charging and lights up green when charging is
complete.
attentIOn: It is extremely important
that you ensure that the first charging
cycle lasts longer than 5 hours but not
longer than 7 hours. Only this will ensure
that the Li-ion cells are fully activated!
please also ensure that you only use a
suitable charger to charge your battery.
• When the charging cycle has been completed, discon-
nect the charger from the mains supply and remove
the battery.
• Your camera is equipped with a lithium ion battery
which does not have to be fully discharged before it
can be recharged. The battery does, however, have a
limited life and can be recharged approximately 300x.
We therefore recommend that, as a rule, you only re
charge the battery when it is exhausted or nearly
exhausted.
Charging times will vary according to the surrounding
humidity and battery charge status.
Inserting the Battery / SD Card
Insert the battery into the camera as follows:
1. Check that the power is off
and open the battery cover
in the direction of the arrow.
2. Insert the battery in the
direction of the arrow.
3. Insert the SD card in the
direction of the arrow.
remove the battery pack when the camera
is not in use.
the sd Card must be formatted in
fat32. Otherwise the Ir camera may not
recognize the memory.
Camera
Battery Status Symbols
The following icons indicate the battery status on the
LCD display.
Battery is sufficiently charged
Low battery
Replace or recharge battery
m
m