14
EN
850W pendulum action jigsaw PJSS 12-230V
Operation
Tips and notes on handling the jigsaw
General information:
•
Keep the venting slots clear to prevent the motor from
overheating.
•
Check the tool in the tool holder for proper fit before every
application. The tool must be firmly locked in place in the
designated holding fixtures in the tool holder.
•
Before every application, make sure that you have selected
the correct tool for the intended use.
Sawing:
•
Only use intact, flawless saw blades. Bent, blunt or
otherwise damaged saw blades could break.
•
When sawing lightweight construction materials, make
sure to observe the legal regulations and
recommendations of the material manufacturers.
•
Before sawing wood, chipboards, building materials etc.
with HCS blades, check the above for foreign objects, e.g.
nails, screws or similar. If required, remove the foreign
objects or use HSS saw blades.
•
Use a narrow saw blade when sawing tight curves.
•
The saw blade should not be longer than required for the
intended cut.
Switching the LED work light and laser on and off
The device is equipped with an LED work light to illuminate the
workpiece and with a laser to mark the cutting path. The laser is
best suited for cuts with a 0° cutting angle.
Warning of laser radiation
Laser class 2, P max.: < 1 mW, λ: 400-700 nm,
EN 60825-1:2014
Do not look directly into the laser beam or the opening
from which it emerges.
Never point the laser beam at people, animals or
reflective surfaces. Even brief eye contact can lead to
eye damage.
Examining the laser output aperture by use of optical
instruments (e.g. magnifying glass, magnifiers and the
like) entails the risk of eye damage.
When working with a laser of class 2, observe the
national regulations on wearing eye protection.
The LED work light and laser can be switched on and off in the
following combinations:
•
LED work light and laser on
1 x =
•
LED work light on, laser off
2 x =
•
LED work light off, laser on
3 x =
•
LED work light and laser off
4 x =
1. Press the button for laser and LED work light (
18
) until the
desired combination is set.
18
