EN
9
cordless pruning shears PGSS 15-20V
Technical data
Parameter
Value
Model
PGSS 15-20V
Nominal voltage
20 V
Motor speed
20,000 rpm
Max. cutting thickness (soft wood) 28 mm
Max. cutting thickness (hard wood) 15 mm
Blade width
5 cm
Blade material
65 Mn (steel)
Weight
1 kg
Type of protection
IPX0
Battery
Multiflex 20 – 2.0 DC
Type
Li-ion
Nominal voltage
20 V
Nominal capacity
2.0 Ah
Rechargeable cells
5 cells
Capacity
40 Wh
Quick charger
Multiflex 20 – 2.0 AC
Input
Nominal voltage
230 – 240 V / 50 Hz
Power input
65 W
Output
Nominal voltage
21.5 V
Charging current
2.4 A
Fusing
3.15 A (slow-blowing)
Charging time
1 h
Cable length
1.5 m
Protection class
II (double insulation) /
Vibration information according to EN 62841
Total vibration emission value a
h
Uncertainty K
0.676 m/s²
1.5 m/s²
Sound values according to EN 62841
Sound pressure level L
PA
68.28 dB (A)
Uncertainty K
PA
3 dB
Sound power L
WA
79.28 dB (A)
Uncertainty K
WA
3 dB
Wear hearing protection.
Excessive noise can lead to hearing loss.
Information on noise and vibration:
•
The specified total vibration
and noise emission values
were measured by means of a test procedure standardized
in EN 62841 and can be consulted for the comparison of
one power tool with another.
•
The specified total vibration
and noise emission values
can also be used for preliminary load assessment.
Caution
Vibration emissions can cause a health hazard if the
device is used for an extended period of time or if it is
not properly handled and maintained.
•
The actual vibration
and noise emission
may differ from
the stated values during operation of the power tool. This
depends on how the power tool is used and especially on
the type of workpiece being processed. Try to keep the
vibration load to a minimum. Exemplary measures for
reducing the vibration load include wearing gloves during
operation of the tool and the limitation of working hours.
All parts of an operating cycle must be considered for this
(e.g. times at which the power tool is switched off and
times when it is switched on but runs without load).
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before
transporting the device, observe the following:
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
Allow the device to cool down.
•
Remove the battery from the device.
•
Put the protective cover on the shear attachment.
The supplied Li-ion batteries are subjects to the requirements of
dangerous goods legislation.
Observe the following when transporting or shipping Li-ion
batteries:
•
The user may transport the batteries by road without any
additional requirements.
•
If transport is carried out by third parties (e.g. air transport
or forwarding company), special requirements as to
packaging and labelling must be observed. This includes
consulting a dangerous goods specialist when preparing
the package.
– Only ship batteries if their housing is undamaged.
– Mask open terminals with tape and pack the battery in
a way that it cannot move inside the packaging.
– Please also observe any other national regulations.