EN
15
cordless pruning saw PCHS 10-20V
Swivelling the handle
The handle cannot be swivelled while the device is running.
1. Remove the battery.
2. Press the angle adjustment button (
1
), swivel the housing
and then let go of the angle adjustment button (
1
) and turn
the housing further until it engages.
1
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
•
Switch the device off.
•
If required, allow the device to cool down.
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
Remove the battery from the device (see Start-up chapter).
•
Put on the protective cover.
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Transport and storage
chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the instructions.
Using insertion tools or accessories other than those
specified in the instructions may cause a risk of injury.
Designation
Article number
Multiflex 20V 2.0 Ah spare battery 6.200.000.303
Multiflex 20V 4.0 Ah spare battery 6.200.000.320
Saw chain
6.215.002.001
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Troubleshooting tasks which require the housing to be opened
must only be carried out by an authorized specialist electrical
company or by Trotec.
Light smoke or odour is emitted during the first use:
•
This is not a fault. These phenomena disappear after a
brief runtime.
The battery does not charge:
•
Check whether the battery is inserted correctly in the quick
charger.
Slide the battery into the quick charger in a way that the
battery terminals engage in the quick charger. The battery
must lock in place in the quick charger.
•
Check the power connection.
•
Check the power cable and mains plug for damage.
•
Check the on-site fusing.
•
Check the quick charger for damage. If the quick charger
is damaged, stop using it. Contact the Trotec customer
service.
•
Check the battery terminals for dirt. Remove any dirt.
•
The battery might be defective and have to be replaced.
Only use batteries of the same type.
