6
EN
local air conditioner PAC 3500 X
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
To make the device easier to transport, it is fitted with wheels.
To make the device easier to transport, it is fitted with a carry
handle.
Before
transporting the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
•
Drain the remaining condensate from the device.
•
Only wheel the device on a level and smooth surface.
After
transporting the device, observe the following:
•
Set up the device in an upright position after transport.
•
Leave the device to rest for 12 to 24 hours, so the
refrigerant can accumulate within the compressor. Wait
12 to 24 hours before switching the device back on! Acting
contrary might lead to compressor damage and a
malfunctioning device. If so, any warranty claims will be
voided.
Storage
Before
storing the device, proceed as follows:
•
Drain the remaining condensate from the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
When the device is not being used, observe the following
storage conditions:
•
Only store the device in a room measuring more than
14 m
2
.
•
dry and protected from frost and heat
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust, if necessary
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
•
Remove batteries from the remote control.
Assembly and installation
Scope of delivery
•
1 x Device
•
1 x Exhaust air hose
•
1 x Hose adapter
•
1 x Adapter cover
•
3 x Window seal
•
1 x Condensation drain hose
•
1 x Screwdriver
•
1 x Remote control
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Start-up
When positioning the device, observe the minimum distance
from walls or other objects as described in the Technical data
chapter.
A
B
C
C
D
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
Only position the device in rooms where potentially leaking
refrigerant cannot accumulate.
