5
EN
Operating manual – local air conditioner PAC 2000 S / PAC 2600 S
Storage
Before
storing the device, observe the following:
•
Drain the remaining condensate from the device.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust if necessary
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
•
Remove batteries from the remote control.
Assembly and installation
Scope of delivery
•
1 x Device
•
1 x Exhaust air hose
•
1 x Hose adapter
•
1 x Exhaust air hose adapter
•
1 x Cover for exhaust air hose adapter
•
1 x Condensation drain hose, length: 1 m,
diameter: 11 mm
•
1 x Remote control
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Start-up
When positioning the device, observe the minimum distance
from walls or other objects as described in the Technical data
chapter.
A
B
C
C
D
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
Set the device up in an upright and stable position.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are completely unrolled.
•
Keep air inlets and outlets as well as the exhaust air hose
connection free.
•
Make sure that no curtains or other objects interfere with
the air flow.
Prior to initial start-up, insert the batteries in the remote control.