Trotec IDS 20, Оригинальное руководство пользователя

Страница: 15 / 26

EN 15
oil heater IDS 20 / IDS 30
Malfunction Meaning Remedy
Fan does not start and flame does not ignite;
operating display is switched off Controller set incorrectly Check whether the controller is set correctly (e.g.
the temperature set at the thermostat must be
higher than the room temperature).
Controller faulty Have the controller replaced by the customer
service.
Fan does not start or switches off during start-up/
operation; operating display flashes in orange No power supply Check the characteristics of the electrical system
(230 V, 1 ~, 50 Hz).
Check the functionality and position of the
selector switch.
Check the fuse for soundness.
Voltage < 175 V Check the supply voltage. The device will restart
automatically when the voltage value
exceeds 175 V.
Voltage > 265 V Check the supply voltage. The device will restart
automatically when the voltage value falls
below 250 V.
Fan switches off during start-up/operation;
operating display illuminated in red, self-
diagnosis indication flashes in orange Flame present prior to ignition of the transformer Instruct the customer service to have the device
cleaned and to have fuel oil residues removed
from the combustion chamber.
Photo cell faulty Have the photo cell exchanged by the customer
service.
Fan switches off during start-up/operation;
operating display permanently illuminated in red,
self-diagnosis indication flashes in red or red/
green Motor winding interrupted or blown Have the motor replaced by the customer service.
Motor bearing blocked Have the motor bearing replaced by the customer
service.
Motor capacitor blown Have the motor capacitor replaced by the
customer service.
No ignition Check the connections of the ignition cables at
the electrodes and the transformer.
Check the position and the distance of the
electrodes.
Check whether the electrodes are clean.
Have the transformer replaced by the customer
service.
Flame monitoring system faulty Have the flame monitoring system replaced by
the customer service.
Photo cell faulty Have the photo cell cleaned or replaced by the
customer service.
Burner is supplied with no or insufficient fuel oil Charge the customer service with the following
tasks:
• to have the coupling between the pump
and the motor checked for soundness
• to have the fuel oil circuit checked for
intruded air and to have the lines and filter
seal checked for tightness
• to have the nozzle cleaned and replaced
Magnet valve faulty Charge the customer service with the following
tasks:
• to have the electrical connections checked.
• to have the safety thermostat L1 checked.
• to have the magnet valve cleaned or
replaced