Trotec IDS 20, Оригинальное руководство пользователя

Страница: 11 / 26

EN 11
oil heater IDS 20 / IDS 30
Filling the tank
The fuel tank cap is located at the side of the device.
ü
Before attempting to fill the tank, wait until the device has
cooled down completely.
ü Only use fuel suitable for the device (see technical data).
1. Position the device on firm, level and incombustible
ground.
2. Unscrew the fuel tank cap (10) by turning it in counter-
clockwise direction.
10
3. Fill the tank.
4. Screw the fuel tank cap (10) back onto the tank by turning
it in clockwise direction. Observe the recesses at the tank
opening and the protrusions at the fuel tank cap. They
must be aligned when attaching the fuel tank cap. Make
sure that the fuel tank cap is firmly attached to avoid
leakage.
Operation
The device may only be used by accordingly instructed persons.
Switching the device on
The device has two operating modes:
• Manual operation
• Automatic operation with external thermostat (article no.
6.100.007.015)
18
14
16
17 15
No. Designation
14 Power supply cable
15 Thermostat socket
16 Selector switch (continuous operation/thermostat
operation)
17 Operating light
18 Reset button with indicator light
Manual operation
For continuous heat generation, here, the device operates
independently of a control unit.
1. Switch the device on by setting the position of the selector
switch (16) to
ON
(continuous operation).
Automatic operation
Automatic operation of the device is only an option with a
connected controller (optional), e.g. a thermostat. The
thermostat is connected to the thermostat socket (15).
1. Switch the device on by setting the position of the selector
switch (16) to ON (thermostat).
ð
To confirm the completion of the start-up process, the
electronic control unit causes the reset button (18) to briefly
flash in red.