EN
6
Operating manual – oil heater IDE 20 D / IDE 30 D / IDE 50 D / IDE 60 D / IDE 100 D
Transport and storage
Notice
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before
transporting the device, observe the following:
•
Switch the device off.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
•
Allow the device to cool down sufficiently.
While
transporting the device, observe the following:
IDE 20 D
•
Only transport the IDE 20 D by use of the transport
handle (2).
IDE 30 D / IDE 50 D / IDE 60 D / IDE 100 D
•
Slightly lift the device by the transport handle (2) until the
rear support no longer touches the ground.
•
Wheel the device to the desired position.
Storage
Before
storing the device, proceed as follows:
•
Allow the device to cool down sufficiently.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust if necessary
Assembly and installation
Scope of delivery
•
1 x Oil heater
•
1 x Carry handle (IDE 20 D only)
•
1 x Frame components (IDE 30 D / IDE 50 D / IDE 60 D /
IDE 100 D only)
•
2 x Wheel (IDE 30 D / IDE 50 D / IDE 60 D / IDE 100 D only)
•
1 x Installation material
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Upon delivery the device is already partially preassembled.
In case of the devices IDE 30 D / 50 D / 60 D and 100 D, the
wheels, frame and transport handle still need to be mounted.
Assembling the wheels (IDE 30 D / 50 D / 60 D / 100 D)
Prior to initial start-up, the wheels and the axle must be
attached to the frame. To do so, please proceed as follows:
1. Slide the axle through the openings at the frame.
2. Attach both wheels to the axle.
3. Attach the locking rings to the axle.
4. Fasten the wheel caps to the wheels.
Info
If necessary, the frame can be disassembled again
(e.g. for storage). To remove the wheels from the axle,
you can carefully loosen the wheel caps and locking
rings by means of a slotted screwdriver.
