EN
5
laser distance measuring device BD22
Technical data
Parameter
Value
Model
BD22
Weight
128.5 g
Dimensions (H x W x D)
130 x 51 x 28 mm
Measuring range of laser
0.05 to 50 m /
0.164 to 164 ft
Measuring range measuring
wheel
0 to 10 m
Measuring units
m/ft/ft+in
Accuracy
±2 mm
Measuring range resolution
1 mm
Number of recordings logged
in the history
50
Operating temperature
0 °C to 40 °C
Storage temperature
-10 °C to 60 °C
Relative humidity
max. 75 %
Laser output
< 1 mW (630-670 nm)
Laser class
II
Device switch-off
After approx. 3 minutes of
non-use
Automatic switch-off of the
laser
After approx. 30 seconds of
non-use
Power supply
2 x 1.5 V battery (type AAA)
Scope of delivery
•
1 x Device
BD22
•
2 x 1.5 V battery AAA
•
1 x Quick guide
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
When transporting the device, ensure dry conditions and and
protect the device from external influences e.g. by using a
suitable bag.
When transporting the product, ensure dry conditions and
protect the device from external influences e.g. by using a
suitable bag.
Storage
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
protected from dust and direct sunlight
•
the storage temperature complies with the values specified
in the Technical data
•
Remove the batteries from the device.
Operation
Inserting the batteries
Note
Make sure that the surface of the device is dry and the
device is switched off.
1. Loosen the cover of the battery compartment (1)with a
screwdriver.
2. Insert two batteries of type AAA (1.5 V, included in the
scope of delivery) into the battery compartment with
correct polarity (+/-).
3. Put the cover of the battery compartment back onto the
device and tighten it with the screws.
Switch-on
1. Press the
button (7) for approx. 1 second.
ð
The display will be switched on and the device ready for
operation.
Basic settings
Switching the acoustic signal on/off
1. Press the
button (13) for a long time to switch the
acoustic signal on or off.
ð
The switch-on/off process is confirmed by a brief
acoustic signal.
Aborting the measurement and deleting the display
1. Briefly press the
C/Off
button (10) to abort the current
measurement or to delete the displayed measured values
one at a time.
