Trotec AIRZON 20000, Оригинальное руководство пользователя

Страница: 7 / 22

EN 7 Ozone generator Airozon 20000
Assembly and start-up
Scope of delivery
• 1 x Manual
• 1 x Device
• 1 x Power cable
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Start-up
When positioning the device, observe the minimum distance
from walls or other objects as described in the Technical data
chapter.
A
B
C
C
D
• Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
• Only put up the device in an upright, stable position on firm
ground.
• Make sure the device is only placed on firm, dry and
vibration-free ground.
• Position the device as close as possible to the centre of the
room to ensure an optimum air circulation.
• When positioning the device, keep a sufficient distance to
heat sources.
• Make sure that no curtains or other objects interfere with
the air flow.
• Do not position the device near inflammable substances
and gases.
• Make sure that the air inlet and outlet are not obstructed.
• Make sure that the device is protected from spray water.
• Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
• Make sure that extension cables are completely unrolled.
• The room temperature should be approx. 5 °C higher than
the usual room temperature.
Connecting the power cable
• Insert the mains plug into a properly secured mains socket
located outside of the room to be cleaned. This enables
you to switch the device off in case of an emergency
without having to access the room.