EN
9
air cleaner AirgoClean® 200 E
Automatic switch-off
ü
The device is switched on.
1. Press the
Timer
button (
10
) until the desired number of
hours is shown on the segment display (
5
).
ð
The timer is now set to the desired number of hours.
ð
The
Timer
LED (
11
) is illuminated.
ð
The device switches off after the set number of hours
has elapsed.
Notes regarding automatic switch-off:
•
Pressing the
On/Off
button (
16
) deactivates the automatic
switch-off function.
Switching the locking function on or off
The locking function prevents the buttons on the control panel
from being used.
Please proceed as follows to lock the control panel:
1. Simultaneously press the
Speed
button (
12
) and the
Mode
button (
15
) for three seconds.
ð
After approx. 3 s, an acoustic signal is emitted.
ð
The locking function is activated.
ð
The buttons on the control panel cannot be used.
2. Press the
Speed
button (
12
) and the
Mode
button (
15
)
for 3 seconds again to deactivate the function.
ð
The device switches back to the previous operating
mode.
Memory function
If you switch the device back on from standby mode, the
settings selected for the operating mode and fan speed are
saved. The timer setting is not saved.
After opening a housing cover (top or side), the device switches
off and then starts again in the last selected operating mode.
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
•
Switch off the device by pressing the
On/Off
button (
16
).
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Transport and storage
chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the operating manual.
Using insertion tools or accessories other than those
specified in the operating manual may cause a risk of
injury.
Designation
Article number
HEPA carbon filter, filter
efficiency 99.97 %
7.160.000.534
Prefilter
7.160.000.533