6
EN
fan heater TFH 19 E
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before
transporting the device, observe the following:
•
Switch the device off.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
•
Allow the device to cool down sufficiently.
Storage
Before
storing the device, proceed as follows:
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down sufficiently.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust, if necessary
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
Assembly and start-up
Scope of delivery
•
1 x Fan heater
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Start-up
Info
Odours might arise upon initial start-up or after a
longer period of non-use.
When positioning the device, observe the minimum distance
from walls or other objects as described in the chapter
Technical annex.
A
B
C
C
D
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
Position the device on even, stable and heat-insensitive
ground in a way to prevent it from tipping over.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are completely unrolled.
•
Make sure that no curtains or other objects interfere with
the air flow.
•
Do not position the device directly below a wall socket.
•
Put up the device in a way that no person, animal or plant
is positioned in its direct flow path upon switch-on.
•
Make sure that the device cannot come into contact with
moisture or water.
