EN
5
pedestal fan TVE 24 S
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before
transporting the device, observe the following:
•
Switch the device off.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
After
transporting the device, proceed as follows:
•
Set up the device in an upright position after transport.
Storage
Before
storing the device, proceed as follows:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
When the device is not being used, observe the following
storage conditions:
•
Store the device in a dry location and protected from frost
and heat.
•
If required, use a cover to protect the device from invasive
dust.
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
•
Remove the batteries from the remote control.
Assembly and start-up
Scope of delivery
•
1 x Device
TVE 24 S
•
1 x Remote control
•
1 x manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Mounting the foot
1. Connect the two parts of the pole by screwing them
together.
2. Connect the foot (4) to the assembled pole (3) by screwing
them together.
Connecting the motor element and pole
1. Connect the motor element (6) to the assembled pole (3).
