Chapter 1
Tropos 7320 Router Installation Guide
36
FIGURE 24
Circuit Board Connection Locations
Resetting the Router
You can use the Reset button on the circuit board to reset the hardware and software and to turn
the router off if it is operating on battery power.
Perform a hardware reset
1.
Remove the connector access cover on the bottom of the router.
2.
Press the Reset button for one second.
Turn the battery-powered router off
Follow these steps if AC power is off and the router is running on battery power:
1.
Remove the connector access cover on the bottom of the router.
2.
Press and hold the Reset button for 3-5 seconds.
trp_110
AC power
connector
Management
port
Reset
Screw holes
for access cover
LED
Threaded hole for
grounding bolt
O-ring gasket
LAN
port