TrojanTwo User Guide v3.8
Page | 32
10.2
Diecut printing mode
To select diecut printing mode go to
TrojanTwo -> Media Settings menu
and choose
‘Diecut’
as
TOF mode (TOF = Top of Form) to describe the top of form algorithm (how to detect the top of the
next label). Press ‘
Save & Apply’
button to apply changes.
Diecut label material has precutted gaps between the labels.
In Diecut mode the label gap/ blackmark sensor has to be calibrated to each applied label
material.
Calibrating the label gap sensor:
LERC10 label eye sensor
AUTOSET
Simply put the gap in view and push and hold the AUTOSET button for 1 second. The AUTOSET LED
will remain on when the setup is complete. If the setup is not adequate, the AUTOSET and Output
LEDs will flash 3 times. This may indicate a backing material that is too dense to penetrate.
UP/DN Adjustments
The Label Eye sensor has the ability to "tweak" the setup incrementally. Simply momentarily tap
the AUTOSET (UP ˄) button, or LT/DK (DN ˅) button to adjust the sensor to a more stable and
repeatable setting. This feature is used when the AUTOSET does not provide the optimum setting
initially.
Example: If the label backing material is inconsistent, or the label material has more translucent
areas coming into view, then the sensor may need to be adjusted slightly for this rare occasion.
Having the ability to fine tune the sensor for changing conditions provides a solution that is easy to
implement and simple to understand.
Light/Dark
Push the LT/DK button to change output from Dark On to Light On...output turns on when label in
view, or output turns on when gap in view.
