Triumph Tiger Sport, Руководство пользователя

Страница: 67 / 184

GENERAL INFORMATION
67
Traction Control Settings
Warning
Do not attempt to adjust the traction
control settings while the motorcycle
is in motion as this may lead to loss of
motorcycle control and an accident.
Warning
If the traction control is disabled, the
motorcycle will handle as normal but
without traction control. In this
situation accelerating too hard on
wet/slippery road surfaces may cause
the rear wheel to slip, and may result
in loss of motorcycle control and an
accident.
The traction control can be set as
described on page
52.
If traction control is turned OFF, the TC
disabled warning light will be illuminated.
The traction control defaults to ON after
the ignition has been switched OFF and
then switched ON again.
Tire Pressure Monitoring
System (TPMS) (if equipped)
The Tire Pressure Monitoring System
(TPMS) is available as an accessory
option and must be installed by your
authorized Triumph dealer. The TPMS
display on the instruments will only be
activated when the system has been
installed.
Warning
The daily check of tire pressures must
not be excluded because of the
installation of the Tire Pressure
Monitoring System (TPMS).
Check the tire pressure when the tires
are cold using an accurate tire
pressure gage, see the Tire section for
more information.
Use of the TPMS system to set
inflation pressures may lead to
incorrect tire pressures leading to loss
of motorcycle control and an accident.
Tire pressure sensors are mounted to
the front and rear wheels. These
sensors measure the air pressure inside
the tire and transmit pressure data to
the instruments. These sensors will not
transmit the data until the motorcycle is
traveling at a speed greater than 12
mph (20 km/h). Two dashes will be
shown in the display area until the tire
pressure signal is received.
An adhesive label will be mounted to the
wheel rim to indicate the position of the
tire pressure sensor, which is near the
valve.