Triumph Tiger 800 XCA 2007, Руководство пользователя

Страница: 82 / 204

General Information
82
Daytime Running Lights (DRL)
Switch (if fitted)
When the ignition is switched
ON and the daytime running lights
switch is set to DRL mode, the daytime
running lights warning light will
illuminate.
The daytime running lights and low
beam headlights are operated manually
using the DRL switch. Press the top of
the switch for DRL mode, and the
bottom of the switch for low beam
headlight mode.
Warning
Do not ride for longer than necessary
in poor ambient light conditions with
the Daytime Running Lights (DRL) in
use.
Riding with the daytime running lights
when dark, in tunnels or where poor
ambient light is apparent may reduce
the riders vision or dazzle other road
users.
Dazzling other road users or reduced
vision in low ambient light levels may
result in loss of motorcycle control and
an accident.
Note:
• During daylight hours the daytime
running lights improve the
motorcycles visibility to other road
users.
• Low beam headlights must be used
in any other conditions unless the
road conditions allow for high beam
headlights to be used.
MODE Button
When the MODE button is pressed and
released it will activate the Riding Mode
Selection Menu in the display screen.
Further presses of the MODE button will
scroll through the available riding
modes, see Riding Mode Selection on
page 35.
Press and hold the MODE button when
a riding mode is selected provides direct
access to the riding mode’s
configuration menu.
For more information on riding mode
selection and configuration, see
page 44.
Direction Indicator Switch
When the indicator switch is pushed to
the left or right and released, the
corresponding direction indicators will
flash on and off. To turn off the
indicators, push and release the switch
in the central position.
Models Equipped with Automatic
Self-Cancelling Indicators
A short press and release of the
indicator switch to the left or right will
cause the corresponding direction
indicators to flash on and off three
times, then go off.
A longer press and release of the
indicator switch to the left or right will
cause the corresponding direction
indicators to flash on and off.
The indicators are automatically turned
off after eight seconds and after riding
a further 65 metres.
To disable the indicator self-cancel
system refer to the Bike Setup section
on page
45.