General Information
81
Note:
• Although the engine stop switch
stops the engine, it does not turn
off all the electrical circuits and
may cause difficulty in restarting
the engine due to a discharged
battery. Ordinarily, only the ignition
switch should be used to stop the
engine.
Caution
Do not leave the ignition switch in the
ON position unless the engine is
running as this may cause damage to
electrical components and will
discharge the battery.
Starter Button
The starter button operates the electric
starter. For the starter to operate, the
clutch lever must be pulled to the
handlebar.
Note:
• Even if the clutch lever is pulled to
the handlebar, the starter will not
operate if the side stand is down
and a gear is engaged.
Hazard Warning Lights
To turn the hazard warning lights on or
off, press the hazard warning light
button.
The ignition must be switched ON for
the hazard warning lights to function,
but the hazard warning lights remain on
if the ignition is switched OFF until the
hazard warning light button is pressed
again.
Left Handlebar Switches
All Models except Tiger 800 XR
ckdf
5
6
1
2
3
7
8
9
10
4
1.
Cruise control adjust switch
2. Daytime Running Lights (DRL) switch
(if fitted)
3.
MODE button
4.
Direction indicator switch
5.
Joystick button
6.
Horn button
7.
Heated grips switch
8.
Front fog lights switch (if fitted)
9.
High beam button
10. Rider and passenger heated seats
switch (if fitted)
The following sections describe the
handlebar buttons and switches
functions.
Cruise Control Adjust Button
The cruise control adjust button is a
two way switch with the top marked
RES/+ and the bottom marked SET/-.
For more information on cruise control
operation, see page
90.
