General Information
110
Universal Serial Bus (USB)
Socket
Warning
The USB socket is not waterproof
unless the waterproof cap is installed.
Do not connect electronic devices
whilst it is raining.
Water in the USB socket could lead to
an electrical problem, resulting in
motorcycle damage, loss of motorcycle
control and an accident.
A Universal Serial Bus (USB) socket is
provided, located under the passenger
seat. The connector provides a 5 Volt,
2 Amp power supply which is suitable
for charging electronic devices such as
mobile phones, cameras and GPS
devices.
To access the USB socket:
• Remove the passenger seat.
• Remove the cap from the USB
socket.
• Connect your device using a suita-
ble USB cable, then stow the device
and USB cable in the space availa-
ble under the passenger seat.
Caution
Make sure that all electronic devices
and cables are safely secured under
the seat when riding.
Make sure there is sufficient space
surrounding any electronic devices for
the seat to close without causing any
damage to the electronic device or the
motorcycle.
• Fit the passenger seat, making sure
that the device or USB cable is not
trapped.
• Turn the ignition on and start the
engine.
Caution
Do not leave the ignition switch in the
ON position unless the engine is
running as this will discharge the
battery.
• When your device has finished
charging, remove the passenger
seat and disconnect the device.
• Refit the USB socket cap and refit
the passenger seat.
Note:
• The USB socket is protected by a
chassis ECM, which will
automatically cut power to the
socket in the event of an overload.
• Power can be restored to the USB
socket by turning the ignition
switch off then on again, provided
that the socket is not still
overloaded.
