Triumph Thruxton TFC 2019, Руководство пользователя

Страница: 52 / 130

General Information
52
Caution
Make sure that all electronic devices
and cables are safely secured under
the seat when riding.
Make sure there is sufficient space
surrounding any electronic devices for
the seat to close without causing any
damage to the electronic device or the
motorcycle.
USB Port Socket
The Universal Serial Bus (USB) socket
allows a 5 Volt USB connection for
charging electronic devices such as
mobile phones, cameras and GPS
devices. Loads up to two Amps can be
connected to the USB socket.
To access the USB socket:
• Remove the seat (see page 50).
• The USB socket is located on top of
the battery.
• Remove the cap.
• Plug the relevant USB adaptor cable
into the socket. Adapter cables are
not supplied with the motorcycle.
Breaking-In
R.P.M.
Breaking-in is the name given to the
process that occurs during the first
hours of a new vehicle's operation.
In particular, internal friction in the
engine will be higher when components
are new. Later on, when continued
operation of the engine has ensured
that the components have 'bedded
in', this internal friction will be greatly
reduced.
A period of careful breaking-in will
ensure lower exhaust emissions, and
will optimize performance, fuel economy
and longevity of the engine and other
motorcycle components.
During the first 500 miles (800 km):
• Do not use full throttle;
• Avoid high engine speeds at all
times;
• Avoid riding at one constant engine
speed, whether fast or slow, for a
long period of time;
• Avoid aggressive starts, stops, and
rapid accelerations, except in an
emergency;
• Do not ride at speeds greater than
3/4 of maximum speed.
From 500 to 1,000 miles (800 to
1,500 km):
• Engine speed can gradually be
increased to the rev limit for short
periods.