Triumph Street Triple R, Руководство пользователя

Страница: 123 / 245

HOW TO RIDE THE MOTORCYCLE
123
To start the engine:
▼
Check that the stop switch is in the
RUN position.
▼ Make sure the transmission is in
neutral.
▼ Pull the clutch lever fully into the
handlebar.
▼ Turn the ignition switch to the ON
position.
Note
When the ignition is switched on, the
tachometer needle will quickly sweep
from zero to maximum and then return
to zero (LCD instruments only). The
instrument warning lights will illuminate
and will then go off (except those which
normally remain on until the engine
starts – see page
40 for TFT
instruments and page 79 for LCD
instruments). It is not necessary to wait
for the needle to return to zero (LCD
instruments only) before starting the
engine.
A transponder is fitted within the key to
turn off the engine immobiliser. To make
sure the immobiliser functions correctly,
always have only one of the ignition
keys near the ignition switch. Having
two ignition keys near the switch may
interrupt the signal between the
transponder and the engine immobiliser.
In this situation the engine immobiliser
will remain active until one of the
ignition keys is removed.
▼ Leaving the throttle fully closed,
push the starter button until the
engine starts.
▼
Slowly release the clutch lever.
Caution
The low oil pressure warning light
should go out shortly after the engine
starts.
If the low oil pressure warning light
stays on after starting the engine,
stop the engine immediately and
investigate the cause.
Running the engine with low oil
pressure will cause severe engine
damage.
▼ The motorcycle is equipped with
starter
lockout switches. The
switches prevent the electric starter
from operating when a gear in
engaged with the side stand down.
▼ If the side stand is extended whilst
the engine is running, and the
transmission is not in neutral then
the engine will stop regardless of
clutch position.