Triumph Daytona Moto2 765 2020, Руководство пользователя

Страница: 63 / 163

General Information
63
Traction Control Settings
Warning
Do not attempt to adjust the traction
control settings while the motorcycle
is in motion as this may lead to loss of
motorcycle control and an accident.
Warning
If the traction control is disabled, the
motorcycle will handle as normal but
without traction control. In this
situation accelerating too hard on
wet/slippery road surfaces may cause
the rear wheel to slip, and may result
in loss of motorcycle control and an
accident.
The traction control can be set as
described on page
42.
If traction control is turned OFF, the TC
disabled warning light will be illuminated.
The traction control defaults to ON after
the ignition has been switched OFF and
then switched ON again.
Tyre Pressure Monitoring
System (TPMS) (if fitted)
Note
The Tyre Pressure Monitoring System
(TPMS) is an accessory fitted item and
must be fitted by your authorised
Triumph dealer.
The TPMS display on the instruments
will only be activated when the system
has been fitted.
Warning
The daily check of tyre pressures
must not be excluded because of the
fitment
of the Tyre Pressure
Monitoring System (TPMS).
Check the tyre pressure when the
tyres are cold using an accurate tyre
pressure gauge, see the Tyre section
for more information.
Use of the TPMS system to set
inflation pressures may lead to
incorrect tyre pressures leading to
loss of motorcycle control and an
accident.
Tyre pressure sensors are fitted to the
front and rear wheels. These sensors
measure the air pressure inside the tyre
and transmit pressure data to the
instruments. These sensors will not
transmit the data until the motorcycle is
travelling at a speed greater than 12
mph (20 km/h). Two dashes will be
shown in the display area until the tyre
pressure signal is received.