Triumph Daytona Moto2 765 2020, Руководство пользователя

Страница: 44 / 163

General Information
44
To change the selected riding mode:
• Press the joystick left or right, or
repeatedly press the MODE button
until the required riding mode is
highlighted in the centre of the
riding mode information tray.
• A brief press of the joystick centre
will select the required riding mode,
and the riding mode icon in the right
hand side of the display will change.
• The selected mode is activated once
the
following conditions for
switching modes have been met:
Motorcycle Stationary - Engine Off
• The ignition is switched ON.
• The engine stop switch is in the
RUN position.
Motorcycle Stationary - Engine Running
• Neutral gear is selected or the
clutch is pulled in.
Motorcycle in Motion
Within 30 seconds of selecting a riding
mode the rider must carry out the
following simultaneously:
• Close the throttle.
• Make sure that the brakes are not
engaged (allow the motorcycle to
coast).
Note
It is not possible to select TRACK or
RIDER modes whilst the motorcycle is in
motion, if the TC settings are set to
TRACK or OFF in either of those modes.
In this case, the motorcycle must be
brought to a stop before the riding mode
change can take place.
If a riding mode change is not
completed, the riding mode icon will
alternate between the previous riding
mode and the newly selected riding
mode until the change is complete or it
is cancelled.
The riding mode selection is now
complete and normal riding can be
resumed.
Information Tray
Warning
When the motorcycle is in motion, only
attempt to switch between the
information tray modes or reset the
fuel information under the following
conditions:
- At low speed
- In traffic free areas
- On straight and level roads or
surfaces
- In good road and weather conditions.
Failure to observe this important
warning could lead to loss of
motorcycle control and an accident.
Note
To access the information tray, the
warning
messages must first be
acknowledged, see page 45.
To view the different information tray
items, push the joystick left/right until
the required information tray item is
shown.
The information tray contains the
following information tray items:
• Warnings and Information
Messages, see page 45