General information
47
High Beam Button
When the high beam button is pressed
the high beam will be switched on. Each
press of the button will swap between
dip and high beam.
Note:
•
If daytime running lights are
equipped on the motorcycle, the
high beam button has additional
functionality.
If the DRL switch is in the daytime
running lights position, then press and
hold the high beam button to turn the
high beam on. It will remain on as long
as the button is held in and will turn off
as soon as the button is released.
Note:
•
A lighting on/off switch is not
equipped on this model. The
position light, brake/tail light and
license plate light all function
automatically when the ignition is
turned to the ON position.
•
The headlight will function when
the ignition switch is turned to the
ON position.The headlight will go off
while pressing the starter button
until the engine starts.
Throttle Control
2
1
1.
Throttle open position
2.
Throttle closed position
All models have an electronic throttle
twist grip to open and close the
throttles via the engine control unit.
There are no direct-acting cables in the
system.
The throttle grip has a resistive feel to it
as it is rolled rearwards to open the
throttles. When the grip is released it
will return to the throttle closed position
by its internal return spring and the
throttles will close.
There are no user adjustments for the
throttle control.
If there is a malfunction with the
throttle
control
the
Malfunction
Indicator
Light
(MIL)
becomes
illuminated and one of the following
engine conditions may occur:
• MIL illuminated, restricted engine
RPM and throttle movement
• MIL illuminated, limp-home mode
with the engine at a fast idle
condition only
• MIL illuminated, engine will not
start.
