Maintenance
80
To inspect the oil level:
• Start the engine and run at idle for
approximately five minutes. Stop
the engine and wait for at least
three minutes to allow the oil to
settle.
• Note the oil level visible in the sight
glass.
• When correct, oil should be visible
in the sight glass at a point midway
between the upper (maximum) and
lower (minimum) markings on the
sight glass.
Note:
• An accurate indication of the level
of oil in the engine is only shown
when the engine is at normal
operating temperature and the
motorcycle is upright (not on the
side stand).
• If it is necessary to top up the oil
level, remove the filler plug and add
oil, a little at a time, until the level
registered in the sight glass is
correct.
Caution
Make sure no foreign matter or
contamination enters the engine
during an oil change or top up.
Contamination entering the engine
may lead to engine damage.
• Once the correct level is reached, fit
and tighten the filler plug.
Oil and Oil Filter Change
Warning
Prolonged or repeated contact with
engine oil can lead to skin dryness,
irritation and dermatitis.
In addition, used engine oil contains
harmful contamination that can lead to
skin cancer.
Always wear suitable protective
clothing and avoid skin contact with
used oil.
Warning
The oil may be hot to the touch.
Avoid contact with the hot oil by
wearing suitable protective clothing,
gloves, eye protection, etc.
Contact with hot oil may cause the skin
to be scalded or burned.
Warning
If the engine has recently been
running, the exhaust system will be
hot.
Before working on or near the exhaust
system, allow sufficient time for the
exhaust system to cool as touching
any part of a hot exhaust system
could cause burn injuries.
The engine oil and filter must be
renewed in accordance with scheduled
maintenance requirements.
