Tritech International Ltd
Tornado Camera OIM
Issue 3
TIL – Eng – Spec – 033
Page 10 of 14
DISASSEMBLY PROCEDURES
To access the internal part of the camera, first remove the nylon retaining cord from the connector end-cap
end of the camera. (It is not necessary to extract the nylon cord fitted between the front part of the housing
and the lens-retaining ring.)
Gently pull the connector end-cap from the main body tube; you may require the aid of a vice with “vee”
blocks to hold the main body tube.
Caution!
Caution!
Before re-assembly inspect the O-ring for integrity, if there are any doubts change it. The O-ring should be
cleaned and lightly smeared with appropriate silicon grease.
Reassemble the camera in the reverse order. Make sure to check that the water block O-ring is in position
and correctly align the water block with the main connector JP1 before gently pushing into position.
Caution!
Lens spacer_________________________________________
End-cap____________________________________________
Body Tube__________________________________________
PSU / Mother board___________________________________
Water corrected port__________________________________
Camera module_____________________________________
Washer support _____________________________________
Spacer camera module_______________________________
Driver board________________________________________
O-ring set____________________________________________
Take care to avoid the pressure ejecting the port too quickly; which
could cause the port and module to be dropped and damaged.
Be aware that the camera module and electronics are attached to the
connector end-cap and will slide out of the body tube when the
camera is parted.
Maintenance of water integrity is the responsibility of the user.
Internal damage caused by water ingress is not covered by product
warranty unless the cause can clearly be identified as a
manufacturing defect.
