SURGE SUPPRESSOR CONNECTION
NOTEBOOK COMPUTER
SURGE SUPPRESSORS
Installation
Plug the surge suppressor into a grounded 3-conductor 120 Volt AC (VAC) outlet. DO NOT use 2-wire extension cords or adapters. When the surge
suppressor is plugged in, the RED Indicator Light will illuminate. This light shows AC power is present. Lack of a proper ground connection will
eliminate common-mode protection. However, you may plug 2-wire devices into the single surge suppressor outlet. The total full load that can be
drawn from the single surge suppressor outlet is 15 amps (1875 watts). DO NOT exceed a total load of 15 amps with equipment plugged into the
surge suppressor.
If the surge suppressor is plugged into a vertically-oriented AC outlet or a wall receptacle with four or more outlets, it should be plugged into the
lower outlets. If the unit is plugged into a horizontally-oriented wall outlet, it should be plugged into the right hand outlet. This will prevent the unit’s
case from blocking any of the other AC outlets.
Connection to the Telephone Line
With the surge suppressor plugged into a properly grounded AC outlet, connection to the telephone line can be accomplished. Refer to the drawing
below depicting proper connection of the surge suppressor. A 6-foot standard phone cord with RJ11 plugs is supplied with the surge suppressor.
Insert one end of the SUPPLIED phone cord into the RIGHT jack. Connect the other end of the SUPPLIED phone cord into your telephone wall
jack. Insert the end of your TELEPHONE’s phone cord into the CENTER jack. Insert the end of your EQUIPMENT’s phone cord (e.g.: laptop
computer’s modem) into the LEFT jack. Insert the EQUIPMENT’s AC line cord into the outlet on the front of the surge suppressor. Your equipment
is now protected from transient spikes and surges on both the AC and telephone line.
1111 W. 35th Street
Chicago, IL 60609
(773) 869-1234
www.tripplite.com
Specifications
Models:
SMP, iGuard
Rated Input Voltage:
120V AC, 50/60 Hz
Rated Current and Load Handling:
15 amps maximum (1875 watts)
AC Spike Protection:
High Voltage Spike Protection:
Handles up to 36,000 amp spikes,
450 joules. High voltage spike protection in both normal and
transverse modes.
Transient Response Time:
<1 nanosecond
AC Outlet:
1 NEMA 5-15R
Telephone/Data Line Spike Protection:
Peak Transient Input Voltage:
6Kv, 10 microseconds
Clamping Voltage:
5V±10%
Response Time:
<1 nanosecond
Interface Receptacles:
3 RJ11 modular input/output
Interconnection Cord:
6 ft. phone cord with male RJ11 plugs
Controls:
Red Indicator Light indicates protection present
Dimensions (HxWxD):
3¼” x 2¼” x 1½”
Weight:
6 ounces
LIFETIME LIMITED WARRANTY
Seller warrants this product, if used in accordance with all applicable instructions, to be free from original
defects in material and workmanshipfor its lifetime. If the product should prove defective in material or workmanship within that period, Seller will repair
or replace the product, in its sole discretion. Service under this Warranty can only be obtained by your delivering or shipping the product (with all shipping
or delivery charges prepaid) to: Tripp Lite, 1111 W. 35th Street, Chicago, IL 60609. Seller will pay return shipping charges. Call Tripp Lite at (773) 869-1234
before sending any equipment back for repair.
THIS WARRANTY DOES NOT APPLY TO NORMAL WEAR OR TO DAMAGE RESULTING FROM ACCIDENT, MISUSE, ABUSE OR NEGLECT. SELLER MAKES NO EXPRESS
WARRANTIES OTHER THAN THE WARRANTY EXPRESSLY SET FORTH HEREIN. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ALL IMPLIED
WARRANTIES, INCLUDING ALL WARRANTIES OF MERCHANTABILITY OR FITNESS, ARE LIMITED IN DURATION TO THE WARRANTY PERIOD SET FORTH ABOVE; AND
THIS WARRANTY EXPRESSLY EXCLUDES ALL INCIDENTAL AND CONSEQUENTIAL DAMAGES. (Some states do not allow limitations on how long an implied
warranty lasts, and some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may
not apply to you. This Warranty gives you specific legal rights, and you may have other rights which vary from jurisdiction to jurisdiction.)
WARNING: The individual user should take care to determine prior to use whether this device is suitable, adequate or safe for the use intended. Since
individual applications are subject to great variation, the manufacturer makes no representation or warranty as to the suitability or fitness of these devices for
any specific application.
The policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice.
ESPAÑOL: p. 2 FRANÇAIS: p. 3 & 4
Grounded AC
Receptacle
SUPPLIED
Phone Cord
Telephone
Wall Jack
TELEPHONE
Phone Cord
EQUIPMENT’s
Phone Cord
EQUIPMENT’s
AC Power Cord
SMP, iGuard
™
9908235.p65
10/14/99, 10:24 AM
1