Tripp Lite NGI-M05-C1, Руководство пользователя, Страница: 24 / 254

24
You can execute a few limited commands when CLI prompt is displayed as below.
L2SWITCH>
If you want to execute more powerful commands, you must enter the privileged mode.
Input command “ enable ”
L2SWITCH>enable
Input a valid username and password when below prompt are displayed.
user: admin
password: admin
L2SWITCH#
4.4. CLI Command Concept
Node Command Description
enable show hostname This command displays the system’s network
name.
configure reboot This command reboots the system.
eth0 ip address A.B.C.D/M This command configures a static IP and subnet
mask for the system.
interface show This command displays the current port
configurations.
acl show This command displays the current access
control profile.
vlan show This command displays the current VLAN
configurations.
The Node Type:

enable
Its command prompt is “ L2SWITCH#”.
It means these commands can be executed in this command prompt.

configure
Its command prompt is “ L2SWITCH(config)#”.
It means these commands can be executed in this command prompt.
In
Enable
code, executing command “
configure terminal
” enter the configure
node.
L2SWITCH#configure terminal

eth0
Its command prompt is “ L2SWITCH(config-if)#”.
It means these commands can be executed in this command prompt.
In Configure code, executing command “ interface eth0 ” enter the eth0 interface
node.
L2SWITCH(config)#interface eth0
L2SWITCH(config-if)#