Tripp Lite NGI-M05-C1, Руководство пользователя, Страница: 23 / 254

23
4. System Status
4.1. Console Port

Connect your computer to the console port on the Switch using the appropriate
cable.

Use terminal emulation software with the following settings:
Default Settings for the Console Port
Setting Default Value
Terminal Emulation VT100
Baud Rate 38400
Parity None
Number of Data Bits 8
Number of Stop Bits 1
Flow Control None

Press [ENTER] to open the login screen.
Setting Default Value
Default Username admin
Default Password admin
4.2. Telnet

Connect your computer to one of the Ethernet ports.

Open a Telnet session to the Switch’s IP address. If this is your first login, use
the default values.
Default Management IP Address
Setting Default Value
IP Address 192.168.0.254
Subnet Mask 255.255.255.0
Default Gateway 0.0.0.0
Management VLAN 1
Default Username admin
Default Password admin

Make sure your computer IP address is in the same subnet, unless you are
accessing the Switch through one or more routers.
4.3. How to enter the CLI?
Press [Enter] key to enter the login command prompt when below message is displayed on
the screen.
Please press Enter to activate this console.
Input “ admin ” to enter the CLI mode when below message is displayed on the screen.
L2SWITCH login: