Triplett 1101-A, Инструкция по эксплуатации

Страница: 3 / 24

WARNING!!!
This meter is NOT to be used to measure High Energy circuits (power
circuitry fused at greater than 4KW, such as distribution circuits,
power entrance circuits, etc.) or circuits classified by CE as
CATEGORY III (CAT III).
2.1
Read all instructions in this manual before using this meter.
2.2 Prior to using the meter in any situation which could result in injury
to the user, in order to verify that the meter is functional and
producing a valid reading, test the meter on a circuit(s) known to have
potentials equivalent to the potential that is to be measured. For
example, before using the meter to determine if an AC power line is
energized with 120VAC, test the meter on a line known to be
energized with 120VAC.
2.3 Do not use this meter with its battery cover open, its rear case open,
or with parts removed. Doing so may damage the meter and/or injure
the user.
2.4 When using this meter in schools and workshops, responsible teachers
or skilled personnel must control the usage of this meter.
2.5 Follow the recommendations of any Trade Organizations or
Regulatory Agencies whose scope encompasses the use of this meter.
2.6 Do not open this meter for maintenance without first disconnecting
the test leads from all external circuitry.
2.7 Repairs and maintenance must only be carried out by qualified service
personnel or qualified electricians / technicians who know the dangers
of, and the safety rules applicable to this type of equipment.
2.8 Always set the meter to the appropriate range or mode before
connecting it to the circuitry to be tested.
2.9 Check the condition of the test leads before making a measurement.
Do not use the test leads if there is damaged insulation or exposed
metal.
2.10 Make sure test leads are properly inserted and seated in the meter's
input jacks. A loose test lead may cause the user to believe that no
hazard exists, when in fact, dangerous voltages or currents may be
present.
2.11 Do not touch the tips of the test leads when making a measurement.
Do not touch live circuitry when making a measurement.
2.12 Before using the meter, examine both the meter and the test leads for
damage. Do not use the meter if damage (damaged insulation,
exposed metal, cracked case, burnt smell, etc.) is evident.
3