6.3
STUDIO INTEGRATION & WIRING
This section describes each of the rear panel connectors and their intended signal assignments.
D-Mon Processor Rear Panel
6.3.1
AUDIO CONNECTORS
All SubD-25 audio connectors are wired according to the Tascam standard – see
9.1.1: Audio SubD-25 Connectors
Connector
Model
Function
#6
AES I/O 1-8
SubD-25
ALL
Connects signals to and from your DAW session in the digital domain:
AES In 1-8 (4xAES3)
= the main signals coming from your DAW session, such as the
main mixes, aux sends, discrete tracks, etc.
The routing of inputs is fully flexible and any combination of formats is possible - for
example: 4 x stereo; 1 x 5.1 + 1 x stereo; 1 x 7.1; and so on.
AES Out 1-8 (4xAES3)
= signals returning to your DAW session, such as the analog
inputs OR AES insert returns (if the INSERT is active).
#7
AES I/O INSERT
SubD-25
ALL
Designed to offer an instant comparison between say a dry main mix (up to 7.1) and
the wet mix returning from an external digital effects processor. The 8 AES in/out
should be wired to and from the insert sends and returns of the external processor.
ATTENTION!
The insert sends
ALWAYS
follow the signals assigned to AES In 1-8 on
connector #6.
When the INSERT is active, all eight returns are switched to AES Out 1-8 on
connector#6. This means:
INSERT OFF
= AES 1-8 signals come from AES In 1-8 on connector #6.
INSERT ON
= AES 1-8 signals come from AES In 1-8 on connector #7.
Insert switching is
ALWAYS
made in one block; it is not possible to insert less
than eight signals. Note that inserts are direct outputs extracted at the AES
input stage. This means that no processing delay is added.
