To install your new Rate Chip:
1. Turn the scale off and unplug
the AC adapter from the wall
outlet. If the scale is connected
to a remote device, unplug that
connection also.
2. The rate chip compartment is
located on the right side of the
scale. If equipped with a
Security Plate, remove the two
screws and set the plate aside.
Use a small flat head screw
driver and gently pry open the
plastic Rate Chip Compartment
Cover.
3. Remove the Rate Chip card by
grasping the edges and pulling
straight out.
4. Insert the new Rate Chip card.
Make sure the card is fully
inserted into the slot (the rate
card can only be installed in one
direction. If it does not fit properly,
turn it over and reinsert).
5. Replace the Rate Chip
Compartment Cover and, if
needed, the Security Plate.
6. Reconnect the AC adapter.
7. Your scale is now ready for use
with its new, updated rates.
IMPORTANT!
NEW SERVICES HAVE
BEEN ADDED!
Be sure to review the keypad
key functions on the back side
of this sheet.
Security Plate
(optional)
Security Plate Screws
Rate Chip Compartment Cover
Triner Scale & Mfg. Co., Inc.
8411 Hacks Cross Road
Olive Branch, MS 38654-4010
TEL: 1-662-890-2385 or
1-800-238-0152
2014 Rate Chip Installation
Instructions For:
Scale Model
Part No.
TS-70PX.............RC001
TS-70xi ..............RC030
Rate Chip Installation
Instructions For:
