Trilithic EASy-PLUS, Руководство по эксплуатации

Страница: 57 / 114

EASyPLUS Encoder/Decoder - Operation Manual V8.09
55
Recording an EAS Audio Message
The EAS audio memory segment of the EASyPLUS is used during all EAS messages other
than the Required Weekly Test. Before originating an EAS message (other than a RWT),
EAS audio must be recorded in order to prevent the rebroadcast of a previous event’s
audio.
1. In the Record/Playback Audio Files group, select EAS from the Audio File pull-
down list.
2. In the Source pull-down list, select Microphone to record from the microphone
built into the EASyPLUS front panel, or select CH5 or CH6 as necessary if using an
external line-level source.
3. Click the Record button and speak into the microphone.
4. Click the Stop button to end the recording session (the Record button changes to
the Stop button while recording is in progress).
5. Under the Speaker Volume slider, select DSP from the Source pull-down list then
click the Program Audio Configuration button.
6. Click the Playback button to verify your recording.
7. When playback completes, click the
Stop
button.
8. Repeat steps 3 through 7 as necessary until you are satisfied with the recorded
message.
In place of recording an audio message, a WAV file may be
uploaded to the EASyPLUS by selecting EAS in the audio file
section; clicking the Upload Audio File button; then selecting
the WAV file.