Revision: 0
FlexxPump4 B
User Manual
42
EN-
6.3.10 FIL-Menu
The FIL-Menu allows you to trigger a defined multiple donation to FP4 B. A total of
40 pump strokes are initiated with the activation. This function enables you to prefill
connected accessories (tubes, distributors, etc.) with the lubricant contained in the
lubricant cartridge, especially during the initial start-up of FP4 B. However, the process
can also be aborted manually at any time.
There is no fault or error at FP4 B.
Remove the activation and programming key from the upper housing of the FP4 B
and place it on the action area. The yellow LED will light up. Leave the activation and
programming key on the action area until FIL is displayed in the LCD. Remove the acti-
vation and programming key from the action area. The yellow LED disappears.
Ü
The LCD flashes together with the green LED twice. The FP4 B starts donating. The
green LED lights up during each donation.
If you do not want to cancel the process: Insert the activation and programming key
into the hole provided on the housing of the FP4 B.
Ü
FP4 B dispenses 40 strokes of lubricant.
If you want to cancel the process: Place the activation and programming key on the
action area and wait until the end of a dispensing process (motor run).
Ü
CLR appears in the LCD.
Remove the activation and programming key from the action area.
Ü
FP4 B stops the FIL command.
Observe the back pressure values displayed on the LCD if they are of interest to you.
