TDcH Compact Headend
EN
20
5.3
Settings
Start with the folder “Settings” to set up the general settings and information of the TDcH compact headend.
5.3.1
IP address of this interface:
This is the IP address of the Management port
(Ethernet 1) of the compact Headend.
It may be necessary to specify a specific IP
addresses for the headend to avoid network IP address conflicts.
Note:
If a PC is connected direct to the Management port with an Ethernet cable, the network address of the PC has to be
in the same range as the compact headend.
The TDcH management port IP addresses can be reset to factory default settings if required. This is done via the reset
button on the headend unit.
5.3.2
System reset
The following reset functions are available:
1.
When the reset button is
pressed (during start up) and
until the LED blinks green, then the system resets to factory defaults.
2.
When the reset button is pressed (during start up) until the LED blinks red, then the system starts in
recovery mode.
