How to use TAM System Explorer
Topology Tree
Information
In order to interact with a register
unfold the
Topology Tree
until the desired register gets visible. The
registers may be hidden, to reduce vertical amount of space occupied by the tree. In order to show
them, click on the
Show/Hide individual registers
Button .
A click on a register node or a register opens the
Register
tab in the tab panel. All registers contained in
the selected register node are listed in the register panel.
3.1.1 Parameters
Parameters are used to configure the drive for the intended application, e.g. to set up the position con-
troller or the encoder. Typically, a parameter value is written when commissioning the drive and re-
mains unchanged, except if the system is changed. Parameters can be stored in a configuration file on
the PC or persisted on the drive (see sections 3.5).
In the
Register
tab in the tab panel the parameters are listed with the following columns:
Register
→ the name of the register, corresponding to the name in the tree
Actual
→ the actual register value stored on the drive
Prepare
→ the register value which will be written to the drive after clicking
Commit
Unit
→ physical unit of the value
Description → short description of the parameter
ServoDrive-SetupGuide_EP018
2022-08-25
9
/
83
Figure 3: TAM Topology Tree and Registers
Show/Hide
Registers
Commit Registers
Revert Registers
