TRI W-G TG1800 Series, Руководство пользователя

Страница: 5 / 12

Page 3
OPERATING INSTRUCTIONS
Adjust Height --To raise or lower the mat table, simply touch the up or down arrow key on the hand switch. The
low voltage hand switch has operating power of VDC/mA of 12/50.
Duty Cycle --System is an intermittent operation; 1 minute on, 9 minutes off.
Capacity --The table is intended to support 750 lbs (333.6 Kilograms).
Casters --Locking the casters is accomplished by pushing down or stepping on the back part of the brake pedal
firmly. To release the brake pedal, push down or step on the upper part.
Intended Use --It is a powered table intended for medical purposes (Class I Device) that is an electrically oper-
ated flat surface table that can be adjusted to various positions. It is used by patients with circulatory, neuro-
logical, or musculoskeletal conditions to increase tolerance to an upright or sitting position; [21CFR890.3760].
At no time should patients be left unattended on the mat table.
Intended User Profile --It is intended to be used by Licensed Physical Therapists, Assistant Physical
Therapists, Occupational Therapists, Assistant Occupational Therapists, and licensed rehab specialists utilizing
a prescribed therapeutic protocol, written by a licensed medical practitioner or physician. It is not intended to
be used by maintenance staff, installers, patients and/or lay persons.
MAINTENANCE
The mat table is equipped with a strong high-performance quiet linear actuator, having a long lifetime and vir-
tually maintenance free; however, conducting routine preventative maintenance checkups are a must. One
must routinely check the actuator for wear on the end mounts and connecting bolts, for unusual noises, for actu-
ator wobbling when extending or retracting the spindle, and that it is operating smoothly, as minimums. Due to
normal wear, it may be necessary to replace the linear actuator. The actuator is non-servicable in the field. Call
customer service for replacement actuator.
The gas springs are used to assist the linear actuator in the first stages of the lifting process and may need
replacing from time to time, due to normal wear. If one should notice an oil leak or oil spot on the floor below
the gas spring, or if table seems to be deficient in power, it may indicate the spring needs replacing. If opera-
tor hears an unusual noise while operating the device, it may be coming from the gas spring, which would indi-
cate it may need replacing. Call customer service to assist in interpreting the nature of the noise.
Due to normal wear, it may be necessary to replace the hand switch or the power cord. Call our customer serv-
ice for replacement parts and/or installation instructions.
Cleaning the vinyl cover is accomplished with a mild detergent and water. Do not use Peroxide, Hylex, Lysol,
or strong cleaning agents as they will discolor and reduce the life of the vinyl. We also recommend diluting
some of the well known over the counter cleaners available before using; such as 409

cleaner with a ratio of
4:1 at a minimum. A soft dust cloth will work to remove dust and lint on the steel frame when necessary.
Any repair should be performed by trained or certified service personnel.