oven tower
cabinet
www.trendstyle.com.au
Step 1
Follow these instructions to
build and attach your cabinet.
Before you get started
All cabinets will need to be attached to the wall using a minimum of
8 gauge 65mm screws if you have a stud wall. If your wall is
concrete, brick or another surface ask your hardware specialist for
advice on the right fixing method.
Make sure you leave plumbing and electrical work to qualified trades
people. Never try this yourself.
For extra strength use exterior woodworking glue when
assembling cabinets.
Hardware included
Tools you will need
To put your trendstyle cabinets together you will need the following tools.
Cordless drill with:
•
Number 2 screw tip
•
4mm drill bit
•
Number 12
countersinking drill bit
Tape
measure
C
90° angle
bracket
x 6
Pencil
Clamps
Safety
gear
Adjustable
square
65mm
wood screw
Spirit level
(900mm recommended)
Wall fixing
(If necessary)
page 1
A
28mm
wood screws
x 8
B
14mm
wood screws
x 20
To help identify panels, counter sunk holes always face
outwards.
All holes that aren’t already pre-drilled should be drilled prior to
screwing using a No 12 countersinking drill bit.
Make sure you always use safety gear like a mask, ear muffs and
glasses when using tools.
Regulations require that a qualified electrician/gas fitter must be
employed for the installation of oven units. Please refer to your
oven installation guide to see if the base of the oven cabinet
needs to be cut out for ventilation before installing your oven.
D
598mm
oven cleats
x 2
E
298mm
oven cleats
x 2
F
598mm
heat deflectors
x 2
G
298mm
heat deflectors
x 2
H
600mm
front panel
x 1
I
heat
deflectors
x 1
