TRENDnet TEW-731BR, Руководство пользователя, Страница: 44 / 62

© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-731BR
41
Enable dynamic routing on your router
Routing > Dynamic
You may want to setup your router to route computers or devices on your network to
other local networks through other routers. If other routers support dynamic routing
such as RIP (Routing Information Protocol), you can enable this feature on your router
to automatically learn the required routes to reach those networks. It is required that
the same dynamic routing protocol and version is also enabled on the other routers in
order your router and the other routers to exchange information about the network.
Note:
Configuring this feature assumes that you have some general networking
knowledge.
1. Log into your router management page (see “Access your router management page”
on page 27 ).
2. Click on
Routing , and click on Dynamic .
3. Select the appropriate dynamic routing protocol and version communicate with other
routers.
• Transmit – Allows your router to send out network information to other
routers so other routers can dynamically build routes to your network.
o
Disabled – Disable sending routing information from your router to
other routers.
o
RIP 1 - Sends out routing information to other routers using the RIP
version 1 protocol.
o
RIP 2 – Sends out routing information to other routers using the RIP
version 2 protocol (recommended if supported by both devices).
•
Receive - Allows your router to receive network information from other router
so your router can build routes to other networks.
o
Disabled – Disable receiving routing information from other routers to
your router.
o
RIP 1
- Receive routing information from other routers using the RIP
version 1 protocol.
o
RIP 2 – Receive routing information from other routers using the RIP
version 2 protocol.
4. Click Apply to save the changes or click Cancel to discard the changes.