TONN/BAT TONN UPS Option or Battery Replacement Installation Instructions TG201133 Issue 2, 12-Jun-2013 1
Installation Instructions
TONN/BAT
TONN UPS or Battery Replacement
Important: Retain these instructions
These instructions shall be used by trained service personnel only
If the equipment is used in a manner not specifi ed by these instructions, the protection provided by the equipment may be impaired.
1
Disconnect Power
2 INSTALLATION
1 UNPACKING
CONTENTS
1 Unpacking
.....................................................................
1
2 Installation
.....................................................................
1
WARNING:
Power to TONN must be OFF when replacing the
battery, or damage will occur.)
TONN/BAT TONN UPS Option or Battery Replacement Installation Instructions
(TG201133)
Disconnect Power
O
I
Switch OFF
2
Remove Cover
Caution:
This unit contains static sensitive devices.
Suitable anti-static precautions should be
taken throughout this operation to prevent
damage to the unit.
BS EN100015/1 Basic Specifi cation:
protection of electrostatic sensitive devices.
It is recommended that the installation should comply
with the local electrical safety installation practices (e.g.
HSE Memorandum of Guidance on Electricity at Work
Regulations 1989, USA National Electric Code).
The TONN/BAT kit can be used as a replacement battery for TONN units requiring a backup battery for back up and shutdown in
the event of power failure, or as a uninterrupterable Power Supply (UPS) for TONN (E) units. See the TONN Data Sheet (TA201127)
for details.
Important
▪
If replacing a battery follow steps (1), (2), (3), (4), (5) and (6)
▪
If using a a UPS follow steps (1), (2), (4) and (5)
