HT/S Space Humidity and Temperature Sensor Installation Instructions TG200990 Issue 2, 19-Mar-2013 1
Installation Instructions
HT/S
Space Humidity and Temperature Sensor
Important: Retain these instructions
These instructions shall be used by trained service personnel only
If the equipment is used in a manner not specified by these instructions, the protection provided by the equipment may be impaired.
1
Dimensions
2
Mounting Requirements
1 UnpackIng
2 InSTallaTIon
It is recommended that the installation should comply
with the local electrical safety installation practices (e.g.
HSE Memorandum of Guidance on Electricity at Work
Regulations 1989, USA National Electric Code).
conTenTS
1
Unpacking .....................................................................
1
2 Installation
.....................................................................
1
3 Maintenance
..................................................................
4
4 Disposal
.........................................................................
4
HT/S Installation Instructions (TG200990)
> 50 cm (20”)
86 mm (3.39”)
26 mm (1.02”)
86 m
m (
3.
39
”)
1.5 m (5 ft)
Replacing an HT/S with HT/S V2:
Re-wire the humidity
connection as described below, set the controller’s input
connected to sensor’s humidity output to voltage, and change
the scaling used by the sensor type module to use the correct
scaling see step (9).